The purpose of NaviScan is to collect data from multibeam and lidar sensors and to generate a file with exact positions of each scan. To do this, navigation information is needed along with gyro, roll/pitch/heave and bathy sensors.
Below there are two NaviScan configuration manuals, one for earlier versions and one updated to NaviScan 9.12.
Table of Contents
1 Introduction
1.1 Related manuals
2 Getting started
2.1 The configuration file NaviScan.BIN
2.2 Tree view or Explorer panel
2.2.1 File level
2.2.2 Sensor type level
2.2.3 Individual sensor level
3 The Toolbar
4 Menu bar
4.1 File
4.2 Equipment
4.2.1 GPS TIME
4.2.2 RUNLINE CONTROL
4.2.3 GYRO
4.2.4 MOTION
4.2.5 BATHY
4.2.6 AUXILIARY
4.2.7 RAWDATA
4.2.8 DOPPLERLOG
4.2.9 NAVIGATION
4.2.10 ECHOSOUNDER
4.2.11 SIDESCAN
4.2.12 PIPETRACKER
4.2.13 LASERSCANNER
4.2.14 Free data format
4.2.15 Special instruments
4.3 View
4.4 Options
4.4.1 Global Parameters
4.4.2 Fansweep port setup
4.4.3 Enable trace log
4.4.4 Open NaviScan tracelog
4.5 Tools
4.6 Help
5 Definitions
5.1 Offsets
5.2 Mount angles